Using Space Designer’s Output Sliders
The output parameters enable you to adjust the balance between the direct (dry) and
processed signals. The parameters that are available are dependent on Space Designer’s
input configuration.
If you insert Space Designer as mono, mono to stereo, or stereo effect, Space Designer
offers two output sliders—one for the direct signal, and one for the reverb signal.
In surround configurations, Space Designer offers four output sliders that together
comprise a small surround output mixer.
Mono/Stereo
Surround
Space Designer Mono/Stereo Output Configuration Parameters
• Dry slider: Sets the level of the non-effect (dry) signal.
• Rev(erb) slider: Adjusts the output level of the effect (wet) signal.
Space Designer Surround Output Configuration Parameters
• C(enter) slider: Adjusts the output level of the center channel independently of other
surround channels.
121
Chapter 7
Space Designer Convolution Reverb
• Bal(ance) slider: Sets the level balance between the front (L-C-R) and rear (Ls-Rs) channels.
• In 7.1 ITU surround, the balance pivots around the Lm-Rm speakers, taking the
surround angles into account.
• With 7.1 SDDS surround, the Lc-Rc speakers are considered front speakers.
• Rev(erb) slider: Adjusts the output level of the effect (wet) signal.
• Dry slider: Sets the overall level of the non-effect signal.