Getting to Know the Ringshifter Interface
The Ringshifter interface consists of six main sections.
Output parameters
Delay parameters
Mode buttons
LFO parameters
Envelope follower
parameters
Oscillator parameters
• Mode buttons: Determine whether the Ringshifter operates as frequency shifter or ring
modulator. See
Setting the Ringshifter Mode
.
• Oscillator parameters: Use these to configure the internal sine wave oscillator, which
modulates the amplitude of the input signal—in both frequency shifter modes and
the ring modulator OSC mode. See
Using the Ringshifter’s Oscillator
.
• Delay parameters: Use these to delay the effect signal. See
Using the Ringshifter’s Delay
.
• Envelope follower parameters: The oscillator frequency and output signal can be
modulated with an envelope follower. See
Modulating the Ringshifter with the Envelope
Follower
.
• LFO parameters: The oscillator frequency and output signal can be modulated with an
LFO. See
Modulating the Ringshifter with the LFO
.
• Output parameters: The output section of the Ringshifter includes a feedback loop and
controls to set the stereo width and amount of the dry and wet signals. See
Controlling
the Ringshifter Output Parameters
.
16
Chapter 1
Distortion Effects